Replace Your Timing Chain

What you will need:

1. Combination Wrenches
2. A Socket Set
3. Torque Wrench
3. A Harmonic Balancer Puller
5. A Three-jaw Gear Puller
6. Screwdrivers
7. Hammer and Punch
8. Gasket Scraper
9. Timing Light
10. Tube of Silicone Sealer
11. Timing Chain Cover Gasket Set
12. New Timing Chain and Gears
13. Drain Pan
14. Antifreeze
15. Jack
16. Jack stands

Before You Start:

Follow these instructions carefully. Read and be sure you understand them before you begin.
Gather together all of your tools and supplies before you begin.
Allow plenty of time to do the job so you don’t have to hurry.
Remember that these are general instructions. For more detailed instructions pertaining to your specific vehicle, consult an appropriate repair manual.
Safety is important whenever you’re working around machinery. Beware of hot objects, sharp instruments and hazardous materials.
Don’t substitute tools unless you’re sure you won’t compromise either your safety or the performance of your vehicle.
Never work on a vehicle that is only supported by a jack. Use jack stands to support the vehicle while you work. Work on a solid, level surface. Never jack a car up on dirt or grass.
Why Replace Your Timing Chain?

Over time, wear on internal working parts of your engine will spell the need for replacement. One of the internal working parts that wear is the timing chain and timing sprockets. The timing chain and sprockets are the connecting line between the crankshaft and the camshaft. As the crankshaft turns, via the timing chain, it drives the camshaft that operates the engine’s valves via the lifters, push rods and rocker arm assemblies The timing of the valves opening and closing at precise intervals is crucial for proper engine operation. As the timing chain and sprockets wear, this precise timing of the valves gradually changes, eventually to a point where replacement is necessary.

Telltale signs of worn out timing chains are:

Rough idle.
Sluggish performance and poor economy.
Sudden engine performance change including the inability to start the engine.
Intermittent backfire through the intake manifold.
Inconsistent ignition timing or a clattering noise coming from the front of the engine.
Before starting the disassembly procedures, I would suggest cleaning the engine with an engine degreaser. A clean engine is easier to work on and helps prevent dirt or contamination from entering the engine during disassembly.



Leave a Reply

Your email address will not be published. Required fields are marked *