Diagram for timing marks for crank shaft and oil pump for 2004 hyundai sonata

Optional Information:
Year: 2004
Make: Hyundai
Model: sonata
Engine: 2.4

hyundai timing belt

Be aware the oil pump pulley drives a balance shaft, and due to the gear reduction in the oil pump the timing mark is only correct once every 720 degrees. Meaning if the oil pump sprocket has spun with the belt off the vehicle and you realign it to the timing mark you have a one in two chance of it being correct. To verify you have the correct position, there is a 14mm bolt in the left hand side of the block (right on the balance shaft ‘tunnel’. When this bolt is removed, you will be able to stick a screwdriver or othr metal object 2.5 inches into the block when it is in the correct position; the shaft also will not turn more than 15 degrees in either direction. When you are out of phase, you will only be able to go in about one inch.

99 kia sporage timing marks

kia timing marks
Crankshaft match marks

Align marks on timing belt pulley and pump body.

Camshaft pulley alignment marks

1. Align marks on camshaft pulleys with alignment marks on seal plate.
2. Install timing belt. NOTE: No looseness should exist on the tension side and at the camshaft pulleys.
3. Loosen tensioner lock bolt.
4. Turn crankshaft 2 revolutions in direction of rotation and check that timing marks are still in alignment.
5. Tighten timing belt tension lock bolt to 27-38 ft lb (32-52 Nm).
6. Apply a force of 22 lbs to timing belt between camshaft sprockets.
7. Belt deflection should measure 0.30-0.33 in (7.5-8.5 mm)

NOTE: Replace tensioner spring if timing belt deflection is excessive.
Timing Belt Installation

kia timing belt

1. Install lower timing belt cover.
2. Install upper timing belt cover.
3. Install power steering drive belt and adjust belt tension.
4. Install fan pulley.
5. Install generator drive belt and adjust belt tension.
6. Install A/C drive belt and adjust belt tension.
7. Install splash guard.
8. Install fan and fan shroud.
9. Install 4 fan bolts. Tighten to 24 ft lb (33 Nm).
10. Install fan shroud mounting bolts.
11. Install fresh air duct.
12. Connect hose to resonance chamber.
13. Connect battery negative cable.